Where is aux in honda accord 2003

The honda accord aux input location is on the dash board of the vehicle, look for the 3. Roomy and stylish interior, tight build quality, smooth ride, powerful and efficient hybrid model, good crash test scores. Tepid handling, brakes should be more powerful. When well-maintained, Honda cars can last up to , miles or about 20 years. Why do Hondas last so long? The system comes with built-in Bluetooth and microphone. The honda pilot aux input location is on the dash board of the vehicle, look for the 3.

Insert the miniplug attached to the audio device into the jack. The audio system switches to AUX mode. There is an input jack on the back of the radio, and you might have an AUX button on the radio, but you have to buy a kit to use that jack in the back.

Learn why people trust wikiHow. Download Article Explore this Article Steps. Tips and Warnings. Things You'll Need. Related Articles. All rights reserved. This image may not be used by other entities without the express written consent of wikiHow, Inc. Get everything ready. Make sure the vehicle is off and parked with the emergency brake up and in use. Refer to the Things You'll Need section at the end of article. Move the shift knob back all the way. Use the flat-blade screwdriver to remove the small plastic cap piece next to the shift knob.

Then, use the flat-blade screwdriver to press down and hold the inside of the uncapped piece and pull the shift knob back all the way. Remove the plastic cover surrounding the shift knob. The cover is attached tightly in 6 locations.

There are 2 in the back corners, 2 on the sides, and 2 in the front corners by the park "P" symbol. Remove it by lodging the flat-blade screwdriver between the plastic cover and rectangular area and pulling up to pop the cover out of place.

The cover is easiest to remove by popping out the front corners located by the park "P" symbol and one of the sides. Once at least 3 locations are out of place, the cover can be removed by just pulling it with some force. Remove the 2 corner screws located near the rectangular area of the shift knob. If the screws do fall into the wiring section, refer to Tips at the end of the article. Open the left compartment and remove the rubber tray.

Do this using the flat-blade screwdriver and lodging it in the seam until it is well underneath the tray and pushing the tray out from underneath as shown in the image below. Remove the next set of 2 screws and remove the compartment.

Use the phillips screwdriver and the long-nose pliers to remove the 2 screws. Then, use your hand to grip the 2 sectioned compartment and pull to pop it out of place. Remove the power outlet wire and remove the last set of 2 corner screws. Remove the wire connected to the power outlet by pressing down on the button on the back of the wire and pulling.

Now, the 2 sectioned compartment can be set aside in order to remove the next compartment, which is the largest one. There is no extra cost to use the app, and it works in your car, too.

Tune to channel 0. Simultaneously press and hold the AUX and Preset 1 buttons. Simultaneously press and hold the Sirius and Preset 1 buttons. Check to make sure your XM radio and your car radio are tuned to the same FM frequency.

Make sure all of the cables between your SiriusXM radio and your stereo system are connected firmly and securely. If the problem persists, it may be interference from another FM channel. Begin typing your search term above and press enter to search.

Press ESC to cancel.